- All New Setup Wizard
- Streamlined AutoEQ
- All New AFS (Advanced Feedback Suppression)
- Mobile Control (Android®, iOS®, Mac®, Windows®)
- dbx Compression
- Graphic EQ
- 8-Band Parametric EQ (adjusted when using the AutoEQ) Input
- Subharmonic Synthesis
- Crossover (supports full range, 2-way, and 3-way systems)
- 8-Band Parametric EQs (used for speaker tunings

Linear measuring microphone for DriveRacks, phantom power 12, 48 Volt, solid metal housing, omnidirectional characteristic, frequency response 20 - 20 KHz +/-1.5 dB

Symmetrische Ein- und Ausgänge (HF-gefiltert) » internes Netzteil » XLR,Klinken und Barrier-Strips-Anschlüsse \r » 45mm Fader (25Hz – 16kHz) » Hardwired Bypass mit Relais » +-12dB Eingangsverstärkung \r » umschaltbare Bereiche +-6dB und +-15dB » 40 Hz Low-Cut Filter pro Kanal mit 18dBOktave (Bessel) \r » 4 LEDs für Ausgangspegel » Clip-LED Anzeige bei Übersteuerungen

Dual 31-Band Graphic Equalizer, Switchable boost/cut ranges of ±6 or ±15 dB, Electronically balanced/unbalanced inputs, Servo balanced/unbalanced outputs, RF filtered inputs and outputs, XLR, Barrier Strip, and 1/4inch TRS connectors, -12dB/+12dB input gain range, 18dB/octave 40Hz Bessel low-cut filter, Chassis/signal ground lift capability

Single 31-band, 1/3-octave Constant Q frequency bands
Switchable boost/cut ranges of ±6 or ±12dB
12dB per octave, 3dB down @ 50Hz low-cut filter
Front panel bypass switch
±12 dB input gain range
4-segment LED ladders for monitoring output levels
XLR and TRS Inputs and Outputs
Frequency Repsonse of <10Hz to >50kHz
Dynamic range of greater than 108dB

Error proof operation to smooth uneven levels, add sustain to guitars, fatten drums or tighten up mixes
New gate timing algorithms ensure the smoothest release characteristics
Program-adaptive expander/gates
Great sounding dynamics control for any type of program material
Separate precision LED displays for gain reduction, compression threshold and gate threshold allow quick, ...

Dual 15-band, 1/3-octave Constant Q frequency bands
Switchable boost/cut ranges of ±6 or ±12 dB
Front panel bypass switch
±12 dB input gain range
4-segment LED ladders for monitoring output levels
XLR and TRS Inpts and Outputs
Frequency Repsonse of <10Hz to >50kHz
Dynamic range of greater than 108dB

XLR balanced ins and outs
Mode switch for stereo 2-way or mono 3-way operation
Low frequency summed (subwoofer) output
x10 range switch on both channels
40Hz high pass (low cut) filter both channels
Phase reverse switch on all outputs
Individual level controls on all outputs
24dB per octave Linkwitz-Riley filters (the professional standard)

Dual 31-band, 1/3-octave Constant Q frequency bands
Switchable boost/cut ranges of ±6 or ±12 dB
Front panel bypass switch
±12 dB input gain range
4-segment LED ladders for monitoring output levels
XLR and TRS Inpts and Outputs
Frequency Repsonse of <10Hz to >50kHz
Dynamic range of greater than 108dB

TRS differentially balanced ins and outs
Mode switches for mono 4-way or stereo 2-way/3-way operation
Low frequency summed (subwoofer) output
x10 range switch on both channels
40Hz high pass (low cut) filter both channels
Phase reverse switch on all outputs
Individual level controls on all outputs

XLR balanced ins and outs
Mode switches for mono 4-way or stereo 2-way/3-way operation
Low frequency summed (subwoofer) output
x10 range switch on both channels
40Hz high pass (low cut) filter both channels
Phase reverse switch on all outputs
Individual level controls on all outputs
24dB per octave Linkwitz-Riley filters (the professional standard)

Error proof operation to smooth uneven levels, add sustain to guitars, fatten drums or tighten up mixes
New gate timing algorithms ensure the smoothest release characteristics
Program-adaptive expander/gates
Great sounding dynamics control for any type of program material
Separate precision LED displays for gain reduction, compression threshold and gate threshold allow quick,...

-Mic Preamp Connector: XLR Floating balanced, Pin 2 Hot
-Mic Preamp Input Impedance: ~4.2kO
-Mic Preamp gain: 0dB to +60dB
-Mic Preamp Phantom Power: +48VDC, applied to XLR pins 2 and 3 through 6.81kO resistors
-CMRR: >40dB, typically 55dB
-Mic Preamp max input level: 0.2Vrms, Gain = 30dB
-Mic Preamp Equivalent Input Noise (EIN): -125dBu, 22Hz-22kHz, 150O source impedance

- Based on the classic dbx 902
- Frequency Control Range from 800Hz to 8kHz
- Expanded Scale LED Gain Reduction Metering
- De-essing Amount Range from 0dB to 20dB
- In/Out Switch
- HF Mode Switch

- Based on the classic dbx 905
- 3-band parametric EQ
- Selectable bell or shelf type filters on low and high frequency bands
- Adjustable Q on each band

- OverEasy® or classic hard knee compression with dbx’s ultra-musical program dependent attack and release times
- Compression ratio variable from 1:1 through infinity:1 to -1:1
- Precise RMS gain reduction and input/output meter displays with calibration control for different operating levels
- True RMS level detection
- Exclusive Infinity+ compression using negative ratios

2 channel Advanced feedback supressor, 24 filters per channel, full LCD display

Multi-format cable tester with Speakon, XLR, TRS, DIN, DMX, banana, cinch and BNC. Ground and 5 pins including their assignment can be checked with LEDs

Multi-format cable tester, divisible with RJ45,RJ11, MIDI, Speakon, XLR, Cinch, DIN, TRS, TS, DMX and banana. Due to the division into transmitter and receiver, even permanently installed very long cables can be tested

- Level and impedance matching function
- Output impedance: > 600 Ohms
- Signal pass through connector
- Output connector: XLR balanced
- Battery LED indicator
- Distortion: (THD) < 0.005% at 1kHz, 0dBu
- Phantom power LED indicator
- Max Input: +12dBu (at 0dB) Level +32dBu (at -20dB) +52dBu (at -40dB)
- Output Noise: <-100dB unweighted
- TS and XLR inputs and outputs

Digital speaker management system, 2x In, 6x Out, 4-band parametric EQ per output, 2x input inserts to select compression, AFS, AGC, notch filter or sub-harmonic synthesizer, Real Time Analyzer with sep. Mic In, 2.7 seconds delay, System Wizard, input terband or parametric EQ, GUI via RS232

Speaker management system, 4x In, 8x Out, optional digital I/Os (CobraNet), Ethernet with HiQnet compatibility, no controls on the front panel, Wizzard, library with many common components, 4x analog XLR inputs, AES-EBU 96K, CobraNet(optional), 8x analog XLR outputs, AES/EBU 96K, virtual

The VENU360 provides all the processing and flexibility you need between your mixer and amplifiers to optimize and protect your loudspeakers. With the latest advancements in dbx’s proprietary AutoEQ™ and AFS™ algorithms, additional input channels, ethernet control via an Android,® iOS,® Mac,® or Windows® device, and updated wizards.

Speaker management system with 3x inputs and 6x outputs and Dante connector, 31-band graphic equalizer, third-octave band real time analyzer, limiter, crossover, compressor, peak stop limiter, subharmonic synthesizer, feedback suppressor, output delay up to 343 m/1000 ms, parametric 8-band output EQ, 24-bit converter and 40-bit floating point unit

Graphic EQ, 2x 31-band, Feedback Eliminator (AFS) with 12 1/80 oct. notch filters, Type V noise reduction, PeakStop Limiter, range switchable to ± 6 dB or ± 15 dB, Low-Cut 40 Hz 18 db/oct. switchable, sym. XLR connectors or terminal blocks, 24 bit DA/AD converter, 113 dB dynamic

16-channel personal monitor controller

Safety panel 1 U, for protection against unauthorised access

Safety panel 2 U, to protect against unauthorized access