• Bekafun
  • Celto Acoustique T4.26 - 4X 2500W amplifier

Celto Acoustique T4.26 - 4X 2500W amplifier

CTO-T426

- Extremely robust design
- 4x 2600W 4 Ohm (4x 1300W 8 Ohm) max power
- TrueSound Class D amplifier with high-speed high-current MOSFETs
- Studio quality preamp with TrueRMS VCA limiters
- PULSAR Push-Pull Switch Mode Power Supply
- MCU controlled 3D-Guard SOM (Smart Overheat Management)
- SuperCharged 105°C Long Life Capacitors
- FEM optimized R:Cool radial heat sinks



2 in stock

Max output Power EIA 1kHz 1% THD (EIA = 33ms ON / 66ms OFF): 4x 1300W 8 ohms | 4x 2600W 4 ohms

Overall gain: 34dB (50 times voltage)

Sensitivity at 8 ohms: 2.03Vrms (+8.4dBu)

Signal to Noise Ratio (A weighted): 112dB

Frequency Response (-1dB): 20~25000Hz

Typical THD (half power, 1kHz, 8 ohms): <0.05%

Typical IMD (1kHz at 4:1, -20dB): <0.2%

Crosstalk (1kHz): >75dB

Slew Rate: >60V/us

Input Impedance: 20 kΩ

Damping factor (1kHz, 8 ohms): >800

Protections: Soft-Start, Short-Circuit, Over and Under-Voltage, Over-Current, Over-Load, DC Output, Temperature, SOM (Smart Overhead Management)

Operating Voltage: 190~250VAC 50-60Hz

Preamp: Proprietary PureSound Circuit for unmatched sound quality (Audiophile capacitors in signal path, High Voltage Opamps, Ultra Low Noise design), Studio grade TrueRMS VCA limiter, Continuous protection, RF protection, Overload protection

Power Supply (PSU): Advanced Switch Mode with 3D-Guard tracking, 105C long life SuperCharged Capacitors

Output stage: Fully Discrete 4th generation proprietary Class D (93% efficiency at full power), Differential circuit for Load-Independent linear frequency response, Half bridge design with high-Speed high-Current MOSFETs, 105C Long Life capacitors

Cooling: Front to back airflow Temperature regulated SUNON MagLev fans (50000 Hours, dustproof) FEA optimized Radial heat-sink for maximum heat transfer

Rear Panel: 4 NEUTRIK XLR Input with latch, 4 NEUTRIK XLR Link, 4 NEUTRIK Speakon NL4, PowerCon 20A (included)

Speakon Wiring: SPK1 = 1+1- CH A / 2+2- CH B | SPK2 = 1+1- CH B / 2+2- Not Used | SPK3 = 1+1- CH C / 2+2- CH D | SPK4 = 1+1- CH D / 2+2- Not Used

Chassis: 19" 2U height, 468mm total depth

Weight Net / Gross: 13kg / 16kg

Datasheet(s)