The PB-05 D reduces the signat at -16 dB, what is sometimes more audible for in ear applications.

The PB-05 E is a cheaper version with the same performance of the "pro" models. It works only with dynamic mics.

The PB-05 M have an attenuation of -42 dB in the "Mic Off" position.

The Optogate PB-09 is our new automatic microphone gate unit, implemented in a table stand. The PB-09 contains a mic on button what can be used as "push to talk" or "mic latch" switch. These different functions are user programmable with 3 dip switches. The PB-09 contains also a galvanically separated trigger input for the mic control. The switching noise is not measureable.

This is a two-component kit consisting of a phantom-powered "transmitter", built in to a XLR connector and a battery-powered "receiver". Used on its own, the transmitter can check the integrity of the cabling to the mixer. If the cable is undamaged and all three wires are connected, a direct tone is sent to mixer. If not a LED mounted in the connector indicates the nature of the fault.

Ken je de situatie? De microfoon op het podium geeft geen signaal aan de FOH-plaats en je moet uitvinden wat het is. Is het de kabel? Is het de multicore of het consolekanaal? De ohmmeter zit nog in de koffer van de truck en de batterij is hoe dan ook leeg ...

Hier is de oplossing: steek gewoon de tester in de microfoonkabel, schakel de fantoomvoeding in en u krijgt onmiddellijk het resultaat

Micswitch with A–B router, mute function

The Mic Mute footswitch is our answer to customer requests who like the idea of the Optogate devices but have different applications where a manual foot switch is the better solution.

For a position under a table

After taking into account our customers suggestions we developed the PB-07. On this model the sensor is on the flat side. Like the other models the Pb-07 will switch on the microphone if someone is in front of the mic. A red status LED indicates if the microphone is switched on. The PB-07 will switch off the microphone if nobody is in front of the mic. The distance can be adjusted between 15cm an

Adapterplate with 2 x 3 pin xlr

This handy device is avaible in two different versions: One a Pink Noise generator and the other a 100Hz sine wave generator. Just connect the XLR generator to a desk, switch on the phantom power and the generator will start. In the case of defective cable in the twisted pair the built in LED flashes 2 or 3 times to indicate a fault on the connector pins 2 or 3. If the LED does not illuminate the

XLR cabletester, dmx signaltester